The One Systems Cross Field Array-2HTH (CFA-2HTH) was designed to provide very high intelligibility and acoustic output where long throw requirements are specified. The enclosure features all 316 (marine) grade stainless steel rigging. The grill assembly and all other fasteners are 304 -grade stainless steel that feature a newly developed coating system allowing the CFA-2HTH to be used in ocean front and marine environments, as well as inland direct weather environments. The CFA-HTH is a nominal 55 degree horizontal by 30 degree array that features a fully rotatable high frequency horn/waveguide. This allows the CFA-2HTH to be used in either a vertical or horizontal orientation and still allows the desired coverage patterns. The high-frequency configuration consists of two large-format, close-spaced compression drivers coupled to a 2” (50.8mm) constant directivity horn. The low-frequency configuration consists of 4 bandwidth optimized 10” (254mm) diameter woofers in a 2 x 2 array. The CFA-2HTH is ideal for both outdoor/direct weather long throw applications and indoor applications in high ambient noise environments. Typical applications are football and soccer fields, baseball fields and large theme park environments. Indoor environments such as basketball and hockey arenas are also well very appropriate venues for the CFA-2HTH, due to the ultra- high system intelligibility.
In order to achieve maximum system performance the CFA-2HTH should be high-pass filtered using a 4th order (24dB/octave) high-pass filter set to 80Hz. This filter frequency can be set using any high-quality DSP based loudspeaker processor.
The CFA-2HTH is a direct weather design that features a three-layer stainless steel grille assembly. The enclosure design is a laminated fiberglass construction with high safety factory structural rigging points molded in the enclosure shell.
The system is also compatible with the One Systems Pole Mount System PM4/M where vertical tilt requirements are specified in a pole mount application. The One Systems PT7/6M is also compatible with the CFA-2 HTH when pan and tilt are both required. The PT76/M is suitable for flat surface mounting only.
The CFA-2HTH has an internal 600-watt autoformer and an internal jumper system that allows the enclosure to be used in either a “Lo Z” (4-ohm) or “Hi Z” configuration. The autoformer taps are 600 watts, 300 watts, and 150 watts. The input will allow for either 70.7Vrms operation or 100Vrms operation. The autoformer is a very low insertion loss (<0.4dB) impedance converter that exhibits very wide bandwidth. The system ingress protection is IP 56.